Fat Fingers

Discussion in 'SolidWorks' started by Ed, Jul 14, 2006.

  1. Ed

    Ed Guest

    I was editing a dimension and my finger hit between a couple of keys at
    the same time. Now when I go to edit any dimension in a sketch, (in a
    part) the calculator and equation dialogue boxes pop up
    automatically.... quite frustrating. In additionI am now not able to
    change the value of some dimensions, especially if it is a degree?

    Any ideas how to "turn off" this automatic feature?

    I tried to close down SW without saving, and to open a different part
    but no such luck. Apparently, I was able to turn some "mode" on.

    Thanks.
     
    Ed, Jul 14, 2006
    #1
  2. Ed

    Jeff Guest

    Ed..... Check to see if your "num-lock" is turned on... If it is off,
    and you try to edit a dimension your equations box pops-up... Hope that
    helps...

    Jeff
     
    Jeff, Jul 14, 2006
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. difference between fingers and multiplicity in simulation

  2. Solidworks 2008 features new and Improved, low fat too!

  3. fat lines on smaller plot

Loading...