'exclude from bom' option has dissappeared with sp3.3???????

Discussion in 'SolidWorks' started by Zander, Feb 23, 2006.

  1. Zander

    Zander Guest

    Subject says it all - can anyone confirm this? I had a drive crash,
    rebuilt my system, installed latest sp, opened an assembly, right
    click on part, component properties and the little switch to exclude
    from bom is just ..... not there anymore.

    Zander
     
    Zander, Feb 23, 2006
    #1
  2. Yep, it's gone. You discovered this in minutes. I wonder why SolidWorks
    didn't?

    Best Regards,
    Devon T. Sowell
    www.3-ddesignsolutions.com
     
    Devon T. Sowell, Feb 23, 2006
    #2
  3. Zander

    Zander Guest

    My var says it will be back in sp3.4 due next week.
     
    Zander, Feb 23, 2006
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.