Error to show the DC Operating Point on Composer ...

Discussion in 'Cadence' started by roland, Jul 9, 2004.

  1. roland

    roland Guest

    Dear All :

    We have some device on schematic can not show it's DC Operator Point ,
    how to fix it ?

    ADE->Results->Annotate->DC Operating Points

    Thank you


    Roland
     
    roland, Jul 9, 2004
    #1
  2. roland

    Erik Wanta Guest

    Roland:
    Do you see the OP results in the results browser?
     
    Erik Wanta, Jul 9, 2004
    #2
  3. roland

    roland Guest

    Dear Erik :
    You mean dc-Op-dc? I can see it .

    Because we have to set the composer editable and then we can show the
    DC Operatin Point ,so I think maybe some enviroment setting is error ,
    or some other initial setting error that cause we can not show the DC
    operating Point
    ....

    Thank you for your support

    Roland
     
    roland, Jul 12, 2004
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. How to get dc operating point data from a swept dc analysis or aparametric dc analysis in ocean

  2. BETA operating point definition

  3. Plotting operating point values in DC sweep

  4. calculating a config word during operating point analysis

  5. Annotating Operating Point in Cadence

  6. How to control what parameters are displayed during DC Operating Point back-annotation?

  7. How to write all dc operating point data from the simulation result ?

  8. Hide/Show components... show ALL or show SELECTED?

Loading...