error in using ocnprint

Discussion in 'Cadence' started by jimmy, Nov 24, 2004.

  1. jimmy

    jimmy Guest

    Hi,

    I always use Ocnprint to save data in cadence. Sometime I encountered
    such a problem. Let me describe it using an example.

    If I want to run a transident analysis for 100us. During the long
    simulation, I like to use direct plot to view the on-going results.
    The problem is: if I viewed the data at 20us. Then if I want to use
    direct plot to view the data again later, I can not see data after
    20us. If I use Ocnprint to save data, I can only save valid data up to
    20us. However, i can still use result browser to view updated data.

    I have no idea what is wrong?

    Thank you for your help,

    jimmy li
     
    jimmy, Nov 24, 2004
    #1
  2. jimmy

    Erik Wanta Guest

    Jimmy:
    I have not tried it but I see a few functions that might help.

    simDrain()
    artFlush()
     
    Erik Wanta, Nov 28, 2004
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.