End to all plot confusion???

Discussion in 'AutoCAD' started by kness, Jan 13, 2004.

  1. kness

    kness Guest

    Let me get this straight.

    There are (basically) TWO variables if you are using a plotter with a roll.

    1. Orientation

    2. Length of paper to be rolled out at given width (24, 36, etc.)

    So why is it when I go to print, I have to sift through all of the possible standards, and envelope sizes that exist? And when I find one, I still have trim the borders.

    There should be two options.

    What orientation, and what length.

    I realize this isn't the case if I am using sheet paper.

    Are there any settings/software where I can completely do away with standard sheet sizes?

    Any help would be appreciated.

    Kelly
     
    kness, Jan 13, 2004
    #1
  2. kness

    Ron Meicho Guest

    Yes you can turn off any unwanted virtual paper sizes. <plot device>
    <properties> <filter paper size> and uncheck any not needed.

    Ron Meicho
     
    Ron Meicho, Jan 13, 2004
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Layer State Confusion

  2. grread confusion

  3. Mline Lisp does all but setvar clayer at the end

  4. the confusion of autodesk

  5. Suggestions for preventing edge/sketch entity confusion in SW 2004?

  6. End of "All-In-One" Microsoft OS

  7. Please end my confusion

Loading...