End notch Weldments tube

Is there an easy way to end notch a weldment tube. I can sketch a
circle and use the cut feature which will give me a 90` notch. But now
how would notch a tube at a 30' angle?

Thanks!!
-Nathan

 

I'm not sure if this is what you are looking for but to get a 30 degree
angle on the end of a welment tube I would try to create a plane (or
sketch a line) at 30 degrees off the end and use the cut-extrude
feature.

 

Use trim/extend tool from weldment toolbar.

 

Thanks Chadli,
That's what i needed to do, create a new plane at 30' from the end
surface of the weldment.

Thanks again!!