eDrawings 2005 won't close down

I like the new eDrawings -- especially the more subtle shadowing. After
creating an eDrawing from my Assembly and leaving eDrawings open, going
back to SolidWorks for a while, I found that eDrawings (the application)
wouldn't close. It wasn't locked up . . . I could manipulate the
eDrawing . . . but it would absolutely NOT close down. Had to close it
with the Task Manager (which did not show it as "Not responding").
Anyone else have this experience. If I get one positive answer I'll
turn it in as an SPR.

'Sporky'

 

No trouble here Spork. Everything works as expected.

Muggs

 

Well, as mentioned, it wasn't locked up. Acted like it was doing
perfectly. ONLY thing wrong was it wouldn't close down. Remember,
though, I left it running while I went back to SolidWorks for a short
while.