driven dimensions in design table

Discussion in 'SolidWorks' started by NOT REALLY ME, Jan 4, 2007.

  1. NOT REALLY ME

    NOT REALLY ME Guest

    Another one for the experts,

    I need to have a driven dimension show up in the design table. Created a
    sketch, used convert entities to place an arc. Dimensioned the arc (which
    was fully defined) and added the driven dimension to the design table but
    the value in the table does not change between the configurations even
    though the actual dimension does. Any ideas?

    TIA,
    Jeff
     
    NOT REALLY ME, Jan 4, 2007
    #1
  2. NOT REALLY ME

    Dale Dunn Guest

    I believe you need to have the table set up to allow model edits to update
    the design table. This will only update when the table is opened. Perhaps
    one of these is the problem.
     
    Dale Dunn, Jan 4, 2007
    #2
  3. NOT REALLY ME

    GTCadGuy Guest

    ....and you will need to rebuild every configuration before you re-open
    the design table - at least that is what I have seen in 2006.
     
    GTCadGuy, Jan 5, 2007
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Design table generated assembly does not stick to its table parameters inside another assembly

  2. Table driven selection

  3. Driven dimensions in spreadsheet

  4. customizing dimensions in design table

  5. Gauge Table & Design Table

  6. Drawing table values linked to values in design table?

  7. Table Driven Part Configurations in Assemblies Question

Loading...