drill point extruded

Discussion in 'SolidWorks' started by Dewittian, Oct 30, 2003.

  1. Dewittian

    Dewittian Guest

    I have a .5" rod with a .156 extruded hole that's supposed to be a drilled
    hole half way through the length of the rod.

    How can I get an extruded 30 degree drill point to be added to the flat end
    of my hole?

    thanks if anyone can help.
     
    Dewittian, Oct 30, 2003
    #1
  2. Dewittian

    Wayne Tiffany Guest

    Two methods:

    First is to extrude the hole to the depth of the point of the drill and then
    put a chamfer into the bottom of it.

    Second is to create the hole with the hole wizard, or at least the same
    method of drawing the side view and revolve cut it.

    WT
     
    Wayne Tiffany, Oct 30, 2003
    #2
  3. Dewittian

    Corey Scheich Guest

    On SW 2003 sp 4.1 I was able to Cut-Extrued to a point by having a draft
    angle of 60° and extrude past the conical point.

    Corey
     
    Corey Scheich, Oct 30, 2003
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Fixing Extruded Arcs

  2. drill holes

  3. Drill bushing part in toolbox

  4. Any one in here draw drill bits, or reamers

  5. Drill Hole Dimensions on prints

  6. Hole Callout - Letter drill size?

  7. solid model of a drill

  8. Need some comments on my Cad Drill .routine

Loading...