Drill bushing part in toolbox

Discussion in 'SolidWorks' started by stephen, Sep 17, 2004.

  1. stephen

    stephen Guest

    Hi All,

    I needed a certain sized drill bushing in an assembly, so I tried to
    change the supplied drill bushing file into one that has multiple
    configs like for the screw file. But I can't. All the configs would
    look the same. Is it because of the equation that is used to drive
    the dimension?

    Thanks,

    Stephen

    A seperate question: I was reading PopSci and learned that CATIA can
    change a side by side fuel cell configuration to a stacked one when
    the width of the car becomes too narrow. How would you do it in SWX?
     
    stephen, Sep 17, 2004
    #1
  2. stephen

    TinMan Guest

    With a Design Table.

    Ken
     
    TinMan, Sep 21, 2004
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. drill holes

  2. New Part could use mating part as background

  3. drill point extruded

  4. Any one in here draw drill bits, or reamers

  5. Drill Hole Dimensions on prints

  6. Hole Callout - Letter drill size?

  7. solid model of a drill

  8. Need some comments on my Cad Drill .routine

Loading...