Drawing Edited

Discussion in 'AutoCAD' started by Jim Dee, Jul 21, 2004.

  1. Jim Dee

    Jim Dee Guest

    Isn't there a variable or command to set DBMOD to 0 as if the drawing hadn't
    been edited? I thought I had done this before, but know I can't remember
    what I did. It may have been an undocumented function.

    Thanks for any help.

    Jim Dee
    www.caddee.com
     
    Jim Dee, Jul 21, 2004
    #1
  2. Jim Dee

    Doug Broad Guest

    acad-push-dbmod and acad-pop-dbmod

    assuming you already haven't made changes to the drawing.
     
    Doug Broad, Jul 21, 2004
    #2
  3. Jim Dee

    Jason Piercey Guest

    acad-push-dbmod
    acad-pop-dbmod
     
    Jason Piercey, Jul 21, 2004
    #3
  4. Jim Dee

    ECCAD Guest

    Look up these functions:
    Search Discussion Group for "DBMOD". Lots of discussions.

    Bob
     
    ECCAD, Jul 21, 2004
    #4
  5. Jim Dee

    Jim Dee Guest

    Thank you for your help all. That's what I was looking for.

    Jim Dee
    www.caddee.com
     
    Jim Dee, Jul 22, 2004
    #5
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Marking Edited Drawings

  2. can SW 2K4 input automatically Part # or Drawing filename into a multiple sheet drawing?

  3. Replacing Drawing Sheet on Multiple Sheet Drawing Package

  4. Scan a paper drawing and convert it to .dwg drawing

  5. VBA AutoCAD querying XREF'ed drawing from inside Current Drawing

  6. New Drawing Tool for Engineering Drawing Project.

  7. Find the drawing scale of current drawing

  8. AutoCAD Drawing Management / Drawing Check-out

Loading...