Dimensioning metes & bounds

Discussion in 'AutoCAD' started by oroynestad, Oct 20, 2004.

  1. oroynestad

    oroynestad Guest

    I'm a newbie to this list as well as ADT 3.3. I've entered a building lot using the surveyor's metes 7 bounds and no I'd like to dimension using these same units - how can I do this?

    Thanks, Ole R.
     
    oroynestad, Oct 20, 2004
    #1
  2. oroynestad

    Maverick91 Guest

    What units are you using?

    Surveyor's units are usually in decimal-feet and degrees-minutes-seconds for angles. What are UNITS set to? What are the units in your dimension style(s) set to?

    Doug Draper
    Lea+Elliott, Inc.
    www.leaelliott.com
     
    Maverick91, Oct 20, 2004
    #2
  3. oroynestad

    oroynestad Guest

    units are decimal-feet and degrees-minutes-seconds. I vaguely remeber a LISP routine (many moons ago) that would place metes & bounds above/below line just by picking the lot lines . . . thanks. Ole
     
    oroynestad, Oct 21, 2004
    #3
  4. oroynestad

    Maverick91 Guest

    LDT will do this for you. I do not know off-hand of a LISP for this.
     
    Maverick91, Oct 21, 2004
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Help with dimensioning an ellipse

  2. Dimensioning the length of a curve

  3. showing z-depth info within dimensioning

  4. Dimensioning Arc Length

  5. Dimensioning Arcitectural/Fractional

  6. Dimensioning

  7. dimensioning

  8. Note is Out of bounds?

Loading...