dimension display using Limit

Discussion in 'SolidWorks' started by samurai, May 2, 2007.

  1. samurai

    samurai Guest

    When using limit for tolerance display dimension, how do i get SW2006
    to display with a line inbetween the upper and lower limit, in a
    stacked format?

    Like .195/.200 (stacked), right now it just displays .195 .200 (they
    are stacked over each other, I would like a line between the stacked
    dimensions when using LIMIT>.

    samurai
     
    samurai, May 2, 2007
    #1
  2. samurai

    fcsuper Guest

    Sam,

    I'm not sure that using a line in that way is compliant with the ASME/
    ANSI Y14.5m standard. The problem with using a line in a limit
    dimension (as far as I can tell) is that it may be misinterpreted as a
    fractional dimension. Is there a reason you are trying to use a
    line? BTW, I looked at both ANSI Y14 1982 and 1994 and found only two
    stacked numbers without a line for limit dims in both releases.

    Matt
    http://sw.fcsuper.com
     
    fcsuper, May 3, 2007
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. What is "Text Display"? Text Display vs. Label

  2. Automatic dimension display

  3. How to display sketch dimension in part

  4. Dimension's Display

  5. Dimension text display in sketches

  6. Turn off Display as Chain Dimension

  7. Global Disable "Display as chain dimension." for ordinate dimensions

  8. display username or computer name on the display panel & logs

Loading...