Default Fence Mode in V8

Discussion in 'Microstation' started by Chris Shaffer, Jul 22, 2003.

  1. Chris Shaffer

    Chris Shaffer Guest

    Is there anyway to change the default fence mode in Microstation V8?
    Currently, no matter what I set it to before I close ustation, when I
    open it back up, it still is set to 'clip'.

    I'd prefer 'inside' as my default.

    Thanks,

    Chris Shaffer
     
    Chris Shaffer, Jul 22, 2003
    #1
  2. Chris Shaffer

    Jon Summers Guest

    Chris ...
    Set the fence mode to your preference, then use menu File|Save Settings
     
    Jon Summers, Jul 22, 2003
    #2
  3. Chris Shaffer

    Dave Preston Guest

    Good point Bear. This does of course assume that the files have been created
    within your own organisation

    --

    Regards
    Dave Preston


    www.cadesignservices.co.uk
     
    Dave Preston, Jul 22, 2003
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Exception error with ads_ssget ; debug mode

  2. SDI mode and reactors

  3. entsel, fail, use fail-point for crossing/fence

  4. Borderlayer as fence in VCAR ?

  5. How to open Layout in Turbo mode, w/ DRD on in "Notify" mode ??

  6. How do I snap when placing a fence?

  7. select by attribute for elements within a fence

  8. silt fence linetype?

Loading...