Deep access to net names in ADE?

Discussion in 'Cadence' started by Svenn Are Bjerkem, May 8, 2007.

  1. Hi,

    When using spectre in stand-alone mode it is possible to reference net
    names hierarchically. This is convenient when I would like to measure
    a signal with another circuit (not a calculator function) as I would
    like the simulator to insert a break on the crossings to get the
    measurement accuracy a bit better.

    In ADE I have the problem that I cannot use "DUT.net1" type of labels
    on nets to make them "probe" down into the hierarchy. I would hate to
    have to route signals through pins all the way up the hierarcy just to
    have the measurement blocks instantiated on the top level.

    Has anybody had experience in this direction, or maybe an idea on
    things to try?
     
    Svenn Are Bjerkem, May 8, 2007
    #1
  2. Hi Svenn,

    See sourcelink solution 11017972 where I give an example of doing precisely
    this.

    Regards,

    Andrew.
     
    Andrew Beckett, May 8, 2007
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.