Custom paper sizes

Discussion in 'AutoCAD' started by Bill DeShawn, Jul 8, 2004.

  1. Bill DeShawn

    Bill DeShawn Guest

    Jaymin writes:

    Hi Bill,

    This question may be very easy to you but for me I've a hard time!

    I would like to plot my drawing in 24" x 48" size, when I select my

    plotter I don't find the same size paper, I find 24x36, 36x48 etc..

    My roll size is 24".

    I'm a beginner in drafting profession.

    Thanks in advance.

    Jaymin

    AutoCad-2000



    First off, it's not that easy. I have found it quite difficult to find ways
    to create custom paper sizes lately. In Windows 98 it was much easier. But
    now, the new drivers supplied don't make it very easy. I also found it a
    tad easier if printing directly to the printer rather than use a PC3 file.
    The PC3 doesn't always support custom paper sizes. Is that what you folks
    have found, or do you have other suggestions?
     
    Bill DeShawn, Jul 8, 2004
    #1
  2. Bill DeShawn

    Bill DeShawn Guest

    Jaymin is using an HP Designjet 500. I tried to download drivers and I
    installed it to plot to a file, but it only gives me letter, legal and A4.
    That's ridiculous. What's happening?
     
    Bill DeShawn, Jul 9, 2004
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Saving custom paper sizes

  2. Custom paper sizes - again

  3. Can`t add Custom Paper Sizes

  4. custom paper sizes

  5. Adding custom paper sizes to pc3

Loading...