cross break fold in a sheetmetal panel

Discussion in 'SolidWorks' started by Damian, Dec 3, 2003.

  1. Damian

    Damian Guest

    Is it possible to have a cross break fold in a sheetmetal panel
     
    Damian, Dec 3, 2003
    #1
  2. Damian

    Arlin Guest

    Short answer...no it is not easily possible

    I usually just sketch a couple lines in the drawing and attach a note
    specifying the cross break.

    You could also use a form feature if you really need a graphic
    representation (for nice pictures). I think this was discussed here
    recently.
     
    Arlin, Dec 3, 2003
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Change Job Name for Front Panel Queue

  2. preset assura LVS panel with skill

  3. Panel Layout and Design

  4. from Pro/E sheetmetal to SW sheetmetal...

  5. Resource Panel

  6. Why Can't SWks Fold Plastic Hinges

  7. Hex Panel Nuts

Loading...