Creating ORB hole

Discussion in 'SolidWorks' started by Nathan Feculak, Nov 27, 2003.

  1. Nathan Feculak

    Nathan Feculak Guest

    I have to creat a ORB style hole. is there any kind of hole wizard add in
    that will help in doing this?
     
    Nathan Feculak, Nov 27, 2003
    #1
  2. Nathan Feculak

    kellnerp Guest

    What is an ORB style hole?
     
    kellnerp, Nov 27, 2003
    #2
  3. Nathan Feculak

    kellnerp Guest

    What is an ORB style hole?
     
    kellnerp, Nov 27, 2003
    #3
  4. Nathan Feculak

    Wayne Tiffany Guest

    O-ring boss, I presume.

    WT

     
    Wayne Tiffany, Nov 28, 2003
    #4
  5. Nathan Feculak

    Nathan Feculak Guest

    Where did you get your 2-d profile?
     
    Nathan Feculak, Nov 28, 2003
    #5
  6. Nathan Feculak

    Ray Reynolds Guest

    Search the web for SAE ports, or if you have a decent hydraulics catalog
    from a vendor (Hydraforce or Parker), they usually have the specs in the
    rear of thier catalogs.
     
    Ray Reynolds, Dec 1, 2003
    #6
  7. Nathan Feculak

    Pmwh Guest

    I found the dimensions in a Parker catalog, then created a library feature.
     
    Pmwh, Dec 1, 2003
    #7
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Hole Chart LISP

  2. Hole Punch

  3. creating a drawing each time creating a part or assembly

  4. Creating a hole in 2-D sketch mode

  5. disable certain hole wizard tapped hole sizes?

  6. Creating a plane through the center of a hole

  7. Want to add your own hole geometry to Hole Wizard?

  8. square hole and round hole coincident

Loading...