Cookie Cutter failure

I'm doing a simple design.Sort of a sunburst. Central circle, external
square. I used cookie cutter trim to trim off radial lines. And I find that
my results aren't perfect. It's too late to go back and see what I might
have done "wrong" and I don't think I did anything wrong. Does anybody else
have knowledge or experience with Cookie Cutter not quite working? That is,
off by a hair.

 

Is EDGEMODE set to 1 or 0?

 

Is EDGEMODE set to 1 or 0?

0.

Changed to 1. No diff. From the help, it wouldn't address the issue.

Draw a rectangle. Draw a line from well in the center to just barely over to
the outside. Cookiecutter can fail to trim. Draw long enough line and it
works fine.

The other issue I had, I can't duplicate now.

 

If the routine uses the TRIM command, I don't think you can trim a closed
pline with a line that only crosses it once unless EDGMODE is set to 1.
Conceptually that would be a BREAK, not a TRIM.