convert UCM key cmd to UCF config varaible.....

I am in the process of eliminating my UCM file and converting it
contents into my UCF. I have successfully translated the following
command.

<from my UCM>
key 'mdl load infosnap'

(to my UCF>
MS_DGNAPPS > C:/Bentley/Program/MicroStation/mdlapps/INFOSNAP.MA

The problem I run into is the Infosnap.ma also loads the Infoglid.ma,
which I do not want loaded...SO

<from my UCM>
key 'mdl unload infoglid'

<to my UCF>
??????????

I also load the CHNGDIM.ma

<from my UCM>
key 'mdl load chngdim'

<to my UCF>
??????????

What can I do in my UCF to produce the same results I got from my UCM?

thanks
redbyrd

 

I'm not sure but why not use the macro recorder and try doing what you
want with manual key in commands then you can review whats happening in
the macro you created to fine tune it if it still needs it .