constraint settings

Discussion in 'Cadence' started by axalay, Nov 13, 2006.

  1. axalay

    axalay Guest

    Why in Allegro PCB Editor I can plase via in pads (in all pads) ? Where
    this tick? I set in design rules via to pin constraint value is 0.15
    mm...
     
    axalay, Nov 13, 2006
    #1
  2. axalay

    me at Guest

    | Why in Allegro PCB Editor I can plase via in pads (in all pads) ? Where
    | this tick? I set in design rules via to pin constraint value is 0.15
    | mm...
    |


    look in >setup>constraints>physical>set values>pad/pad direct connect
     
    me at, Nov 14, 2006
    #2
  3. axalay

    axalay Guest

    that set is "ALL ALLOWED"
     
    axalay, Nov 14, 2006
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. A question about Constraint Manager

  2. Unified Constraint Management (61+)

  3. Any way to read technoly rules from Constraint group other thanfoundary ?

  4. Pro/DESKTOP newbie question: radial constraint possible?

  5. WF3 automatic "new constraint"

  6. Printer settings override plot settings

Loading...