Confirmation Corner Vanishing

I never really thought much of the "confirmation corner". I found out
though that I use it quite a bit. I discovered this because it randomly
dissapears and I miss it. Every day I have to go into options and recheck
"enable confirmation corner". Has anyone else noticed options such as this
resetting themselves? Any cures?
Mike

 

Mike,

I Don't use the conirmation corner, but I've noticed similar behavior with
"single command per pick". It keeps turning itself on, randomly, on both my
work and home machines.

Regards

Mark

 

do you use any maco's that might turn it off?

 

LOL I hadn't noticed. Sometimes my left hand lags behind and evidently
skips a beat.

Corey

 

I use the confirmation corner and have noticed this, but had no idea
why it happened or what I was doing to trigger its occurence.... Until
now...

I use a library feature in all sheet metal parts for dropping a
cut-extruded "RR" onto the surface which should be face up when the
part is cut. Sometimes, I have to edit the sketch for that feature
after it has been dropped onto the surface. At some point during this
edit, the CC goes away and has to be reselected as an option.

I've given up and now use the RMB instead, but I'll now sleep better
knowing what caused this.