Configurations

How do I incorporate extrusion/cut depths in configurations? Also, I
would like my configurations drive things like hole arrays and hole
sizes. Is this possible as well?

 

How do I incorporate extrusion/cut depths in configurations? Also, I

This can be done in multiple ways. You can use a design table or do
it by hand.

To use a design table simply refer to the dimensions in question by
their name. If you double-click your extrusion or cut you'll see the
extrusion dimension on the model. Double click the dimension and
you'll see the name. Of course, you can change the dimension right
there, except that you want to pull down the button on the right that
allows you to tell SW that the change you are making is for the
current config only. Same sort of thing for hole arrays.

-Martin