Component configuration keeps changing

Discussion in 'SolidWorks' started by Bruce, Aug 27, 2008.

  1. Bruce

    Bruce Guest

    I have a problem with an assembly. One of the components in the
    assembly is a weldment that has a welded and a machined configuration.
    Every time I open the assembly, the part comes in as the unmachined
    configuration. In the assembly it is listed as the machined
    configuration. I open the part, change and save the configuration and
    then resave the assembly.

    NExt time I open the part, it all happens again. What am I missing?
     
    Bruce, Aug 27, 2008
    #1
  2. Bruce

    j Guest

    Check the properties of that part in the assembly and make sure it does
    not have the "Use model's in use or last saved configuration" toggled on
    in the configuration information area
     
    j, Aug 27, 2008
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.