command line problem

Discussion in 'AutoCAD' started by Julian Brotherton, Nov 16, 2003.

  1. In version 2002 the command line has become detached from the main screen
    and no matter what I try I can not get the command bar to re-attach it's
    self to the main screen. Can any one help ??

    JB
     
    Julian Brotherton, Nov 16, 2003
    #1
  2. Tried that. It never changes shape; hence it won't dock.
    Tried using a tool bar and it worked fine, but not the command line.

    JB
     
    Julian Brotherton, Nov 16, 2003
    #2
  3. The only thing I know that stops it from docking is if you are holding down
    <ctrl> whilst you are dragging it.

    Not sure if there is any other setting that might have the same effect
    though.

    Matthew
     
    Matthew Taylor, Nov 16, 2003
    #3
  4. Julian Brotherton

    Smackypete Guest

    Are you holding the "Ctrl" key while doing this? If not,
    then it WILL dock. Sometimes, you have to move the command
    line down until it is almost off the screen before it will
    "change shape". Keep trying.
     
    Smackypete, Nov 16, 2003
    #4
  5. Julian Brotherton

    Ben Guest

    Check by right clicking on the left side of the command bar that 'allow
    docking' is active.

    kr
    Ben
     
    Ben, Nov 16, 2003
    #5
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.