CMI and custom C code

Discussion in 'Cadence' started by fogh, Feb 10, 2004.

  1. fogh

    fogh Guest

    Hi All,

    I am looking at the options for system design in analog-artist. Of
    course verilogAMS is number 1 on the list, but I was wondering about the
    possibility to (mis)use the CMI interface in order to run custom block
    models. More specifically, a matlab guru could compile his matlab
    models into CMI shared objects.

    Did any of you try this ? What it the performance of the result ? (I
    suspect spectre would not converge so well on a 20-pin block model that
    is packed with if-then-else. )
     
    fogh, Feb 10, 2004
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. compare managers code with a drafters code

  2. Documentation of custom code.

  3. CUSTOM MNU LOAD WICH WILL LOAD ALL OTHER CUSTOM FILES VIA MNL (HOW)

  4. Good book/documentation for CMI (Cadence Spectre)?

  5. Password on the code prevents the code from running

  6. Userform Code vs Module Code

  7. Run Excel VBA code from AutoCAD VBA code

  8. SCR saves without a save being code (scr code attached)

Loading...