Checker/Diamond Plate Hatch

Discussion in 'AutoCAD' started by Dr. After, Mar 5, 2004.

  1. Dr. After

    Dr. After Guest

    So anyone have one usable in r2002? I basically just need one with simple
    short lines representing the raised diamond or checker pattern. Thanks in
    advance!
     
    Dr. After, Mar 5, 2004
    #1
  2. Dr. After

    Kent Cooper, AIA Guest

    Forgot to mention that the diamond-plate hatch patterns I just sent have a
    base "row" spacing of 1 unit in the diagonal direction between parallel
    elements.

    Kent Cooper
     
    Kent Cooper, AIA, Mar 5, 2004
    #2
  3. Dr. After

    Dr. After Guest

    I kept getting an error message when trying to use this one.
    It would show up fine in the GUI but would not apply to any area for some
    reason.
     
    Dr. After, Mar 5, 2004
    #3
  4. Dr. After

    Dr. After Guest

    These worked great and I got the single line one for the simplistic look
    when needed.
    Thanks!
     
    Dr. After, Mar 5, 2004
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Direction of polyline checker.

  2. Get plate thickness

  3. Sheet \ Plate Cut Matrix

  4. Spell Checker

  5. Making the 2nd plate match the hole locations of the 1st plate

  6. Can I extrude a plate with a hole?

Loading...