CG on Drawing

Discussion in 'SolidWorks' started by Oneball, Jun 11, 2008.

  1. Oneball

    Oneball Guest

    I'm looking for a way to call out and dimenson the center of gravity
    on an assembly drawing. Any help would be greatly appreciated.
     
    Oneball, Jun 11, 2008
    #1
  2. Oneball

    fcsuper Guest

    fcsuper, Jun 11, 2008
    #2
  3. Oneball

    Oneball Guest

    I ran the macro and I'm able to see the CG on my drawing, however I'm
    not able to select it and dimension. Any suggestions? Thank you

    -Rob
     
    Oneball, Jun 11, 2008
    #3
  4. Oneball

    fcsuper Guest

    Rob,

    That's odd. Not what I expected. Maybe try making an equal point on
    a 2D sketch and see if you can dim that.
     
    fcsuper, Jun 12, 2008
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. can SW 2K4 input automatically Part # or Drawing filename into a multiple sheet drawing?

  2. Replacing Drawing Sheet on Multiple Sheet Drawing Package

  3. Scan a paper drawing and convert it to .dwg drawing

  4. VBA AutoCAD querying XREF'ed drawing from inside Current Drawing

  5. New Drawing Tool for Engineering Drawing Project.

  6. Find the drawing scale of current drawing

  7. AutoCAD Drawing Management / Drawing Check-out

  8. drawing locks up in 1 drawing only

Loading...