CELLS NOT TRANSLATED DURING STREAM-IN

Discussion in 'Cadence' started by RC MURALI, Nov 25, 2009.

  1. RC MURALI

    RC MURALI Guest

    Hi,

    I streamed-out a layout block in IC6.1 and tried to do stream-in in
    IC5.4.

    While doing the stream-in, all the cells in the block were scanned but
    only a few cells were actually translated (saw the PIPO.log file).

    But the same gds file, if I stream-in in IC6.1, all the cells are
    translated.

    Is there any option that I need to enable while stream-out/stream-in?

    I am not using any layer-map file.

    Can you help me to resolve this?
     
    RC MURALI, Nov 25, 2009
    #1
  2. RC MURALI

    Marc Heise Guest

    Would be good to see your log to give advice. Maybe you work
    with reference libs and you don't have them in IC5 ?
     
    Marc Heise, Nov 25, 2009
    #2
  3. RC MURALI

    Andrew Beckett Guest

    Marc Heise wrote, on 11/25/09 10:17:
    Or maybe you specified a top cell in IC5141, and not in IC61, and so were only
    importing a proportion of the design.

    The IC5141 and IC61 log files from stream in would allow us to answer, which is
    why Marc asked for it.

    Regards,

    Andrew.
     
    Andrew Beckett, Nov 25, 2009
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Stream In problem

  2. Pcells: Stream Out

  3. stream-out & stream-in with techfile

  4. Not saving waveform data during trans analysis

  5. Stream out & Stream in: Virtuoso

  6. V8 Cells vs. V7 Cells

  7. spaceball - NOT removing detail during pan zoom rotate

  8. Items not displaying during move or copy

Loading...