Can't Unsuppress Sketch

I am unable to unsuppress the two sketches that make up a hole wizard
feature. The hole feature is unsuppressed, but not the sketches that
comprise it! If I try to edit the position sketch, I get a message to
first unsuppress the sketch. What should I do??

I've tried rolling back to right after the feature in question. There
are no parent sketches/features suppressed.

SWx 2006 SP4.0

 

Are there any features above that which are supressed or have sketches
where key lines were deleted which were referenced in your sketch as
"On Edge"?

Bo

 

Hi Bo,

No, there aren't any features above that are suppressed. The strange
thing is that if I go back a number of revisions of the part (as I make
changes to the part I save as a new part and increment the revision
number in the file name), the feature behaves properly. The hole
positions are defined by distances only, not On Edge. At a certain
revision number, though, I encounter the problem of not being able to
edit the sketch.

Could it be some problem to do with Hole Wizard and saving the part in
a newer release of SWx, if the part was originally created in an
earlier version of SWx?

Tim

 

You may be onto something with the version change.

See the other recent thread on "sp4 - what 's the verdict so far?"

Bo