Can't make relations in 2007 sp3.1

Discussion in 'SolidWorks' started by Matt Smith, Apr 17, 2008.

  1. Matt Smith

    Matt Smith Guest

    I'm still using 2007 and I just started noticing today that SolidWorks
    is not letting me add relations between a sketch of one part and
    geometry of another part. Say I click on a corner of part "A" and
    then ctrl-click a point of my sketch in part "B". I used to get the
    option to make coincident. Now all I get is a selection window that
    claims the only selection I've made is the point in my sketch in part
    "B" even though I see the corner of part "A" still selected.

    The only option I know that affects this is the setting "Allow
    multiple contexts for parts when editing in assembly". That option is
    checked. Is there another option I'm not aware of that I need to
    change?
     
    Matt Smith, Apr 17, 2008
    #1
  2. Matt Smith

    Matt Smith Guest

    Thank you! That was it.
     
    Matt Smith, Apr 17, 2008
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Can I make IF do OR OR ??

  2. How can I make buttons in tool palletes stick?

  3. Can you make deisel clickable?

  4. make a cone in sheet matel, then make a flat pattern

  5. Can't install 2006 SP3.1 - MSI file issue

  6. Control used to make Pack and Go table in SWX 2007

  7. SWX 2007 SP3.1 Broken Out Section

  8. Solidworks 2007 & Explorer 2007 installed from Image

Loading...