Can't Change Density in SW2005

Discussion in 'SolidWorks' started by Wayne Tiffany, Nov 15, 2004.

  1. Wayne Tiffany

    Wayne Tiffany Guest

    Has anyone turned this one in yet? I'm running in to the same issue - can't
    set a part to UHMW density, and there isn't a material already defined for
    it.

    WT
     
    Wayne Tiffany, Nov 15, 2004
    #1
  2. Wayne Tiffany

    Sporkman Guest

    I just reported it to my VAR. YOU report it separately. The squeaky
    wheel gets the grease.
     
    Sporkman, Nov 15, 2004
    #2
  3. Wayne Tiffany

    Wayne Tiffany Guest

    I don't know if this was mentioned, but it appears that the value is
    changeable until you actually assign a material to the part and then remove
    it. After that it isn't changeable.

    WT
     
    Wayne Tiffany, Nov 15, 2004
    #3
  4. Wayne Tiffany

    Sporkman Guest

    That wasn't my experience. I had assigned no Materials to any of the
    parts that were problematic.
     
    Sporkman, Nov 16, 2004
    #4
  5. Wayne Tiffany

    Wayne Tiffany Guest

    Just tried in SP1.1 - fixed!

    WT

     
    Wayne Tiffany, Feb 15, 2005
    #5
  6. Wayne Tiffany

    CS Guest

    that is such a great idea to go way back and say that it was fixed. There
    have been times that I wondered if something had ever been fixed and how far
    up the SP list you have to go to get to it.

    Corey
     
    CS, Feb 15, 2005
    #6
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. How to solve layout Minimum Density Area across chip / CHIP Area must be >= 14%

  2. TSMC 025 minimum density of a CTM area design rule.

  3. Assura question on density checking

  4. How can I check pattern density by Diva?

  5. soc encounter keeps increasing the density

  6. DRC ERROR "minimum density"

  7. Change Density when Changing Configurations...

  8. Can't Change Density in SW2005

Loading...