bug in measurement tool SW2005

Discussion in 'SolidWorks' started by M, Dec 20, 2005.

  1. M

    M Guest

    SW2005 SP5

    Is there anyone else who has problems with measurement tool? Sometimes that
    tool just dies if used in assembly between sheetmetal part and weldment
    part. This appears always and only with weldment. I have had this problem
    since SW2005 SP0.1. Restarting SW helps sometimes for a minute sometimes for
    a day but nearly always when I use weldment I find this bug..

    In this company I am not alone with this problem, there is few guys who has
    found this same.
     
    M, Dec 20, 2005
    #1
  2. M

    M Guest

    Clear selections don't help. Normally when I point some edge, face... it
    will be selected to a measure tool list and all result will be shown. When
    tool is dead I couldn't select anything. I may point everything but none of
    selections goes to list. Measure window is there but it is empty and remains
    empty until I restart Solidworks.
     
    M, Dec 21, 2005
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Hspice capacitance measurement

  2. spectreRF measurement question

  3. When the corner tool and sequence of measurement statements

  4. Corner tool: How to reset / delete measurement list?

  5. What is the common strategy to do RF simulation and measurement with pads?

  6. PXF for VCO PSRR measurement

  7. Unbalance measurement

  8. SW2004 Folder/Mass Measurement Bug

Loading...