broken link

Discussion in 'SolidWorks' started by john gaskell, Apr 27, 2006.

  1. john gaskell

    john gaskell Guest

    For some reason there is no link between my 3d model and my 2d drawing. When
    I make an alteration in my 3d the 2d drawing stays the same.

    Can anyone help?
     
    john gaskell, Apr 27, 2006
    #1
  2. A few things come to mind, the first two usually being the problem.

    1. Do a RMB on the drawing view and open the model from there. (I know,
    you already have it open, but a common mistake is that the view isn't
    looking at what you think it's looking at.)

    2. Also note, for sure, what config is being referenced by that view.

    3. Rebuild the drawing.

    4. Anything lightweight?

    5. Drop in another view of it and see if it's correct.

    6. Detached drawing?

    7. Do your views have crosshatching on them indicating they need to be
    updated?

    WT
     
    Wayne Tiffany, Apr 27, 2006
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.