Break View minus center lines

Discussion in 'SolidWorks' started by Brian Cannon, Sep 19, 2003.

  1. Brian Cannon

    Brian Cannon Guest

    There seems to be a bug with the Break View command in SW2003. After
    the Break View is created, all center lines that were in the original
    view disappear and new ones cannot be added, nor can center marks be
    added. Can Anyone confirm this or know of a work-around?

    BC
     
    Brian Cannon, Sep 19, 2003
    #1
  2. Brian Cannon

    Krister L Guest

    Yepp...this is a bug...and has been for quite a while....
    I don't really know of a good workaround....I tried the other day to insert
    the center line manually, but I couldn't mate it to the shaft properly so i
    gave it up. Same thng with dimensions....in a round part with break out view
    they act very strange.

    Krister

    Brian Cannon <> skrev i
    diskussionsgruppsmeddelandet:
    ....
     
    Krister L, Sep 20, 2003
    #2
  3. Brian Cannon

    Matthew A. Bush Guest

    Two work round's off the top of my head are

    1. Create an axis in the part & then show the axis in that view.
    or
    2. Show temp axis, draw a center line & make them collinear.


    Matt B.
     
    Matthew A. Bush, Sep 22, 2003
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Center lines for dimension lines.

  2. BREAK lines with gap

  3. SW 2004 break lines

  4. Dangling center marks and center lines

  5. Break Lines...

  6. Break Dimension Lines

  7. Break dashed lines automatically

  8. Break lines in intersections?

Loading...