Blob Printing

Discussion in 'AutoSketch' started by Len Rafuse, Oct 8, 2004.

  1. Len Rafuse

    Len Rafuse Guest

    I had several blobs appearing on my plots. It turns out they should
    have been arrow heads. But other arrow heads printed fine.

    The blobs had been set to 3 pixel rather than hairline. Once they were
    reset to hairline, they plotted fine.
     
    Len Rafuse, Oct 8, 2004
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Lines disappear when plotting - Thread from Printing-Plotting Discussion

  2. Reduced printing of layout tabs.

  3. Printing grips?

  4. Printing the layer manager list

  5. Printing from Virtuoso (or printing GDSII)

  6. Any suggestions on how to form an organic blob?

  7. Printing Says 11x17 but its printing 8x11

Loading...