been playing around with SW2008 and..

Discussion in 'SolidWorks' started by WormSign, Oct 12, 2007.

  1. WormSign

    WormSign Guest

    I just thought I'd let you know that the "Export Flat Pattern to DXF/DWG" is
    pretty sweet. Right click on your flat pattern and make the pick. You have
    the options of including or excluding bendlines. I did a test on a part
    that had counter sunk holes on one face and counter bored holes on another
    face and SW was 'smart' enought to get the proper diameters onto the flat.
    This will be a big time saver for us.

    Now the UI is a different story, I saw the roll out presentation and even
    took notes but for the most part I'm lost when it comes to finding a
    command. But from what I saw in the roll out I think it will eventually be
    a plus.

    Wormsign off
     
    WormSign, Oct 12, 2007
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.