Basic Rect to Sweep Fillets

Discussion in 'SolidWorks' started by Bo Clawson, Oct 16, 2003.

  1. Bo Clawson

    Bo Clawson Guest

    Swks 2003 has been iffy on putting fillets at an intersection of a
    rectangular "bar" interseting a loft of elliptical profiles.
    Sometimes it works & sometimes it does not. I can ask it to put a
    ..015 or .001" radius on a clearly defined edge where there is obvious
    room and it says the radius is too large. That is not acceptable to
    me.

    Is Swks 2004 any better in this regard?

    Bo Clawson
     
    Bo Clawson, Oct 16, 2003
    #1
  2. Bo Clawson

    Corey Scheich Guest

    Have you tried using face fillets. sometimes this fixes it. Sometimes not.
     
    Corey Scheich, Oct 16, 2003
    #2
  3. Bo Clawson

    Art Da Fart Guest

    Yeah, a face fillet will give you an even fillet all the way around. Or you
    can add hold lines and see if that helps
     
    Art Da Fart, Oct 16, 2003
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. 2 part question - path/rect --> pin & CCAR power route

  2. Surface Fillets, SldWks 2003, haphazard terminology

  3. Fillets are hard in 2004

  4. fillets - how?

  5. Pipe weld other than fillets

  6. Getting fillets to work on 3D solids

  7. Fillets

  8. Making 3D fillets (aka rounded edges) on 3D objects with curved shapes

Loading...