"AutoPopulate" the ToolBox Properties dialog

Discussion in 'SolidWorks' started by Richard Doyle, May 24, 2004.

  1. Richard Doyle

    Richard Doyle Guest

    I have set up a series of custom fasteners in ToolBox and added them using
    the "add my parts" wizard. I would like to populate the Part No. and
    Description dialog box that comes up when you insert something from the
    ToolBox - the area below the drop downs where the radio buttons for List by
    Part Number and List by Description are located.

    Can it be done?
     
    Richard Doyle, May 24, 2004
    #1
  2. Richard Doyle

    Johnny Geling Guest

    I'm not sure but look at how de Toolbox is build up. The fields shown in
    the dialogbox are build up bij configuration table in the database. In
    the past I did some experiments with it and made own description in the
    available fields.

    Johnny
     
    Johnny Geling, May 25, 2004
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Properties Dialog box

  2. Launch Layer dialog box while my dialog is open

  3. Properties dialog box

  4. Getfiled dialog box verse dialog box thru command line

  5. toolbox, shared, read only - howto change bom properties?

  6. properties dialog box and microtrend

  7. Custom Properties in Toolbox Parts

  8. Toolbox custom properties gone haywire!

Loading...