Autocad97 LT printing propblem

Discussion in 'AutoCAD' started by Mouse, Mar 14, 2007.

  1. Mouse

    Mouse Guest

    Hi all and thank you in advance,

    I am trying to help a friend print (to scale) on his A3 HP DeskJet
    1280 printer. I know very little about AutoCadLT97 but it appears
    that
    it has a list of "plotters" ???? you can select from and the 1280
    (printer) model is not there. I've tried looking for specific
    Autodesk
    drivers on the Autodesk site and HP but can't find anything there.


    The symptoms are that when you print or print preview, half of the
    drawing is cut off. I've checked all the obvious issues like that the
    printer is the default printing device. The printer is set up for A3
    and that the drawing scale is correct in AutoCad (mm). In desperation
    i've even tried "fit to page" but then the scale is incorrect.


    Any advice would be greatly appreciated.


    Ta
    Mouse
     
    Mouse, Mar 14, 2007
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Lines disappear when plotting - Thread from Printing-Plotting Discussion

  2. Reduced printing of layout tabs.

  3. Printing grips?

  4. Printing the layer manager list

  5. Printing mode of a layer

  6. Printing from Virtuoso (or printing GDSII)

  7. Printing Says 11x17 but its printing 8x11

Loading...