: Autocad using VBA applications

Sub: Autocad using VBA applications

Problem : To rotate the UCSICON for filleting two lines in different co-ordinates.

Dear Sir,

I want to rotate the UCSICON about x-axis and y-axis through VBA codings. I can use the VPOINT options, but it gives the results only as SW isometric, SE isometric,
NE isometric and NW isometric. By using VPOINT options, I couldn't fillet the two lines, which lies on the X-Z plane. So that I need to rotate the UCSICON . Any options in VBA codings to rotate the UCSICON please give me the suitable solutions to the following mail ids.

1.
2.
3.
4.

,

 

Hi,

The UCSICON is purely a display to show the current UCS.

You will not be able to modify the ICON except in as much if you modify the
UCS, then the icon will display the results of the change.

--


Laurie Comerford
CADApps
www.cadapps.com.au

codings. I can use the VPOINT options, but it gives the results only as SW
isometric, SE isometric,

the two lines, which lies on the X-Z plane. So that I need to rotate the
UCSICON . Any options in VBA codings to rotate the UCSICON please give me
the suitable solutions to the following mail ids.

 

At the command line, "UCS n x 90 " will rotate the current UCS 90 degrees
about the X axis, which is what you want. In VBA, there is not a way to
rotate a UCS, you have to redefine it using 3 new points. Or you can use
the VBA line
SendCommand "UCS n x 90 "

James

codings. I can use the VPOINT options, but it gives the results only as SW
isometric, SE isometric,

the two lines, which lies on the X-Z plane. So that I need to rotate the
UCSICON . Any options in VBA codings to rotate the UCSICON please give me
the suitable solutions to the following mail ids.