Augers and spirals

Discussion in 'AutoCAD' started by Ted Clore, Mar 18, 2005.

  1. Ted Clore

    Ted Clore Guest

    Can anyone suggest a way I can use a formula to make two things.

    1) I need to draw different augers, for instance, 4" dia, with the flight of
    each auger at 4" apart.

    2) A spiral like a sea shell that starts at 16" dia and each spiral is 4"
    closer to the center.

    Your suggestions are appreaciated.

    Ted
     
    Ted Clore, Mar 18, 2005
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. pros and cons of setenv and vla-put-???

  2. treedepth and treemax and ram

  3. Program activate in a drawing and execute and an other one

  4. Cell libraries and place and route

  5. schematic check and save and the time stamps

  6. Simple Question about Spirals

  7. Spirals

  8. Spirals, helix and other eningeering curves

Loading...