area command fails in 2d due to z coordinates differing??

Discussion in 'AutoCAD' started by Robert Treadwell, Feb 6, 2005.

  1. Robert Treadwell

    Robert Treadwell Guest

    I am trying to get a simple area in autocad 2004 lt.
    When I connect the points I get a message that says the points had differing
    z points. I am in 2d mode and all line properties show "0" z coordinate
    values. Any help would be appreciated.
    Thanks
    Kevin
     
    Robert Treadwell, Feb 6, 2005
    #1
  2. Robert Treadwell

    Randall Culp Guest

    POINT FILTERS
     
    Randall Culp, Feb 9, 2005
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. How to solve layout Minimum Density Area across chip / CHIP Area must be >= 14%

  2. Extraction data problem due to "Sudden dead of Simulation"

  3. UltrasimVerilog on Linux terminating due to a Segmentation fault signal

  4. Control is not coming out from leHiCreatePath() fn due to nestability

  5. ICFB Visual Problem due to XServer

  6. Split repeat region due to table length

  7. Is this possible, area of a sheetmetal part (square area)

  8. Triming or deleting a hatched area within a hatched area, after the fact

Loading...