Applying hole table to drawings.....Need advice from this group

Discussion in 'SolidWorks' started by rphillipchuk, Mar 25, 2006.

  1. rphillipchuk

    rphillipchuk Guest

    Hi All

    I am hoping that the expertise in this group will help me understand
    Solidworks a little bit better.... I have constructed a plate with
    different hole dimensions....I am able to create a drawing that uses
    the Hole table for sizes and dimensions.......
    The problem I have is that the "X" "Y' zero is in the corner of the
    plate...... thus producing a document that is referenced to the
    corner.......I need the dimensions from the center of the plate.not the
    corner.......Is it possible to do this? I did construct the plate
    with the center of the plate at X zero Y zero but I am having
    difficulties moving the coordinate system from the corner to the
    center...
    Any advice



    Ron
     
    rphillipchuk, Mar 25, 2006
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.