any body inform me how to increse out put

Hi all,
I want to know how to increase out put of eps cups production.
At present we have 8 cavity cup mold and have 7 machines at the rate
of six cycle per minute we r producing only 200K pieces only . it is
very low out put . i want to improve this production up to 600k please
suggest me
thank you
raj

 

I don't believe this is the correct forum for this discussion. Nor do
I think you'd like my answer to your question (namely that this kind
of information usually requires an expert which would be paid for his/
her services). However, you may wish to provide more information if
you want assistance from these forums.

Matt Lorono

 

Seven machines times 8 cavities times 6 cycles per minutes should give you
(assuming 100% yield for now) 336 parts per minute. That gives you 20,160
parts per hour. Are you only running 10 hours a day to give you 200K parts
per day? If that is the case, you can run more hours per day to increase
your output to over 400K parts per day. If you can't increase the time you
run, then you either have to add machines, put more cavities on each
machine, reduce your cycle time, reduce your scrap rate, or some combination
of the above.


Jerry Steiger
Tripod Data Systems
"take the garbage out, dear"

 

What are you using for feedstock and what temperatures are you running
the mold at? What testing have you done with machine timing and
temperatures?

TOP