Annotations Font macro

Discussion in 'SolidWorks' started by dbq, Nov 6, 2004.

  1. dbq

    dbq Guest

    I created a macro to change the arrow parameters in draw mode and it
    worked fine. I was also able to set the Linear Dimension Precision
    within the same macro and it worked as well (though
    AltLinearDimPrecision did not work). My main problem however was with
    my attempt to set the Annotations Font under Document Properties. I
    could not create a macro for either Note, Dimension, Detail or Section
    under Annotations Font. When I went to edit the macro, the macro was
    essentially empty. Has anyone run into this before?

    TIA

    Paul
     
    dbq, Nov 6, 2004
    #1
  2. dbq

    Devon T. Sowell Guest

    Hello-
    Look in the SolidWorks API Help for these topics:
    User Preference enumeration values
    swDetailingNoteTextFormat
    Best Regards,
    Devon T. Sowell
    www.3-ddesignsolutions.com
     
    Devon T. Sowell, Nov 6, 2004
    #2
  3. dbq

    Corey Scheich Guest

    NOTE: 2003 will allow you to open a macro with no indication that it is
    being opened read-only. Then you save and nothing is saved. Lost alot of
    work because of this. I always check the last saved date.

    Corey
     
    Corey Scheich, Nov 8, 2004
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Wildfire 2 'Annotations' sub-menu

  2. Assembly annotations

  3. Annotations visible in Photoworks rendering?

  4. show assy annotations, turn off part annotaions

  5. Reference Annotations in an Animation

  6. Extract annotations using API's

  7. Font substitution even though font is present

  8. SHX font to True Type font mapping

Loading...