Angled Datums

Discussion in 'Pro/Engineer & Creo Elements/Pro' started by agent32vume, Aug 9, 2004.

  1. agent32vume

    agent32vume Guest

    For some reason I cannot create a datum with an angular reference from
    another datum. I can use an edge for the through pick, but if I use a plane,
    I don't get the angle pick in the menu after I pick the through Plane. I
    don't get ANY picks in fact. All selections are grayed out!

    I have used these functions alot in the past without problem. I even
    reinstalled the program.

    Any suggestions?

    David M. Gillespie
     
    agent32vume, Aug 9, 2004
    #1
  2. agent32vume

    Solids Guest

    Dave

    Assuming your using Wildfire, did you hold the CTRL key down after you selected
    the axis?
     
    Solids, Aug 9, 2004
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Insert a Cell on an angled line, and have the line break - automatically?

  2. Insert a Cell on an angled line, and have the line break - automatically?

  3. Layer Off All Datums etc. In A Top Level Assembly

  4. Wildfire and datums on the fly

  5. angled dimension not wanted

  6. Angular Datums

  7. How to hide part's datums of subassembly in main assembly?

  8. datums?

Loading...