ADE corner tool does not start up in VNC

Discussion in 'Cadence' started by fogh, Jul 24, 2005.

  1. fogh

    fogh Guest

    Hi All,

    Using ic5033 , Xserver from VNC4 with solaris, the corner tool simply
    does not pop-up/map. No error message in icfb or stderr. I checked that
    xauth and fontpaths should not be a problem, but did not really
    investigate. The corner tools is OK with other Xservers.

    Has anyone seen that before ?
     
    fogh, Jul 24, 2005
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. When the corner tool and sequence of measurement statements

  2. Corner tool: How to reset / delete measurement list?

  3. slow performance for schematic composer (on VNC) for large grid spacing or when it is turned off.

  4. ADE XL issue, simualtion does not run

  5. how to avoid trying starting ADE L, but directly ADE GXL

  6. flexLM does not start

  7. Running SolidWorks using VNC

  8. Break Corner vs Corner Trim

Loading...