Abstract generation rules

Discussion in 'Cadence' started by renee, Jun 23, 2008.

  1. renee

    renee Guest

    Dear all,
    When I tried to generate abstract view from the layout, it
    needed abgen.rul file, but I cannot find it in the AMI05. Is there any
    way that I can generate it myself, or where can I find it?

    Thank you very much!
     
    renee, Jun 23, 2008
    #1
  2. renee

    renee Guest

    Sorry. I used "find . -name "abgen.rul"" command and found abgen
    rules. But when I run Abstract-> run abgen->abgen, there was an error
    "no raw graphics layer exists in the tech file: via
    6 via = geomOr("via")"

    Should I modify the abgen.rul file?

    Thank you very much for your help!

    Renee
     
    renee, Jun 23, 2008
    #2
  3. renee

    Andrew Beckett Guest

    renee wrote, on 06/23/08 16:21:
    Renee,

    Was the abgen.rul anything to do with the technology you're using? If the rule
    file is looking for a layer "via", and you don't have a layer "via" - the
    chances are that the rule file is going to have other problems.

    You're asking technology-specific questions to a wide audience with little
    knowledge of the technology you're using.

    Far better to ask whoever provides the technology setup.

    Regards,

    Andrew.
     
    Andrew Beckett, Jun 24, 2008
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Some questions about Abstract Generator.

  2. why the abstract can't creat boundary?

  3. SOS！What's wrong in the tf of Abstract generator would cause SEGV error??

  4. VXL-placer form -- how to auto-populate the field: rules?

  5. Virtuoso Compactor Rules for tsmc .18 native

  6. Scripting aptivia and abstract generator

  7. Abstract generation problems

  8. Calibre Rules

Loading...