A serious problem with PCD (Passive Component Designer) on IC5141

Discussion in 'Cadence' started by Mohammadreza Pourakbar, May 20, 2010.

  1. Hi all,

    I am trying to get into PCD (Passive Component Designer) in IC5141 on
    Sun system. The current version of Cadence which is using here is as
    below,

    sub-version 5.10.41_USR6.127.29 (32-bit addresses) CDB version

    When I am running icfb with technology file, everything is fine for
    Schematic and Layout. The cadence is working properly. But when I am
    gonna use PCD, I It cannot load the Technology file that I am using.
    It is suppose to work because I am starting PCD after loading the
    design kit.
    The error occurs when I wanna save the tech file as internal
    technology file and this error is up:

    Segmentation Fault.

    Then I cannot do anything.

    I would appreciate, if someone can give me some advice.

    Cheers,

    Mohammadreza
     
    Mohammadreza Pourakbar, May 20, 2010
    #1
  2. Mohammadreza Pourakbar wrote, on 05/20/10 09:19:
    Hi Mohammadreza,

    I don't know why this would happen, but I should point out that VPCD is
    end-of-lifed and has been for about 18 months now.

    You might want to try a later hotfix version of IC5141 to see if that fixes it,
    together with the latest available MMSIM release with VPCD (MMSIM71 - you didn't
    say which version of MMSIM you're using). MMSIM72 does not contain the product
    any more because (as I said) it's end-of-lifed.

    Regards,

    Andrew.
     
    Andrew Beckett, May 28, 2010
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.